Quick start guide
SynJ SB67148
DECT 6.0 4-line
expansion deskset
for use with AT&T model
SynJ SB67118/SB67138
Message playback
You can play the messages from your deskset
mailbox and the general mailbox. If you have
new messages, the system plays them (in
chronological order) automatically when you
access the mailbox.
Listen to new messages in the deskset mailboxsten to new messages in the deskset mailbox
When the deskset is not in use, press
/MAILBOX.
Listen to new messages in the general mailbox
When the deskset is not in use, press
/MAILBOX.
Press DIR or CID to scroll to
General mailbox. Press the Select softkey.
Press the Select softkey again to choose
Play all.
Options during message playback
When a message is playing, you can adjust
the playback volume, skip, repeat, or delete
the message.
Press VOL+ or VOL- to adjust the message
playback volume.
Press or /SKIP to skip to the next message.
Press or /REPEAT to repeat the message.
Press twice to hear the previous message.
Press X/DELETE to delete the message. The
system announces, “Message deleted.”
Press the Back softkey to stop the playback
and return to the mailbox.
Press EXIT to stop the playback and exit.
NOTE: Refer to the user’s manual for complete
installation and operation instructions.
1.
2.
3.
•
•
•
•
•
•
Join a call in progress
Press and hold the desired LINE 1-LINE 4 key to
join the call.
Three-way conference calls
You can set up a three-party call by using two
lines at the same time. You can also join an
intercom call with a call on an outside line. The
outside call must be established first because an
intercom call cannot be placed on hold.
Make a three-way conference call
Make or answer an outside call.
Press HOLD and call someone on another line,
or start an intercom connection.
-OR-
Call someone on another line, or intercom
someone. The first line is automatically put
on hold.
Press the Conf softkey at any time to begin
the three-way conference.
Intercom calls
You can use the intercom feature to initiate
conversations with any system device not in use.
Press the INT key on the deskset.
Press DIR or CID to choose a destination
device.
-OR-
Press (star key) for the main base, 1-0
for extension 1-0, or # (pound key) for all
extensions.
Press the Select softkey.
The screen displays Calling X:Handset X
(X represents the extension number [1-0],
Handset X represents the handset name),
Calling
*
:Base or Calling All.
1.
2.
3.
1.
2.
3.
4.
Push to talk (PTT) intercom
When the deskset is not in use, press and hold
PTT on the side of your handset to broadcast your
voice to the main telephone base and all other
extensions. When the connection is made, both
the caller and the destination parties hear two
beeps. Only one extension may speak at a time.
Record a call
While on a call, press the Option softkey.
Press DIR or CID to scroll to
Record call on. Press the Select softkey.
The recording starts and the system
activates the call privacy automatically. The
screen displays -PRIV and -REC and the
timer starts counting.
To stop recording and continue the call, press
the Option softkey and then press the Select
softkey to choose Record call off. The system
saves the conversation into the deskset
mailbox.
-OR-
The recording ends when you disconnect
the call.
1.
2.
3.
4.
2
© 2010-2011 Advanced American Telephones. All Rights Reserved.
AT&T and the AT&T logo are trademarks of AT&T Intellectual Property
licensed to Advanced American Telephones, San Antonio, TX 78219.
SynJ
TM
is a trademark of Advanced American Telephones.
Printed in China. Issue 3 AT&T 01/11.
For document downloads, FAQs and more, visit
our website at www.telephones.att.com
or call 1 (888) 915-2007. In Canada, dial
1 (866) 288-4268.
Deskset basic operation Deskset basic operationDeskset basic operation
Make, answer or end a call
Make a call
Lift the corded handset.
-OR-
Press SPEAKER, HEADSET or a desired line
key (LINE 1-LINE 4).
Wait for a dial tone, then enter the telephone
number. The screen displays the elapsed time
as you talk.
Answer a call
Lift the corded handset; or press SPEAKER or
HEADSET.
End a call
Place the corded handset back in the deskset.
-OR-
Press SPEAKER while you are using the
speakerphone.
-OR-
Press HEADSET while you are using the corded
headset.
Place a call on hold:
While on a call, press HOLD. The
LINE 1-LINE 4 indicator for the line on hold
flashes slowly in red. After the call has been on
hold for more than three minutes, a beep sounds
every 30 seconds.
If you are using the speakerphone, the
speakerphone turns off automatically when you
press HOLD.
To resume the call, press LINE 1-LINE 4 of the
call on hold.
Switch among lines
Press LINE 1-LINE 4 of another telephone line to
make or answer another call. The current call is
put on hold automatically.
To return to the first call, press the original
LINE 1-LINE 4. The second line is put on hold
automatically.
1.
2.
•
•
•
To Next Page
