AT&T TL88102 - Using the Menus; Menu Navigation

6
Option 2: Installation with separate line jacks
Install
DSL filters (not
included) are
required if you
have DSL high-
speed Internet
service.
The DSL
filter must be
plugged into the
telephone wall
jack.
Plug one end of the clear telephone
line cord into the line 1 telephone wall
jack or a DSL filter.
Plug one end of the black
telephone line cord into
the line 2 telephone wall
jack or a DSL filter.
Plug the large end of the
telephone base power
adapter into a power
outlet not controlled by
a wall switch.
Raise the
antenna.
Route the power
adapter cord
through this slot.
Plug the small end of
the telephone base
power adapter into
the power adapter
jack on the back of the
telephone base.
Plug the other end of the
clear telephone line cord into
the LINE 1/L1+L2 telephone
jack at the back of the
telephone base.
Plug the other end of
the black telephone
line cord into the
LINE 2 telephone jack
at the back of the
telephone base.