AT&T TL92270 - Handset settings

21
Bluetooth
Bluetooth setup
Replace an active device
You can replace an active device with a device on the paired devices list even
if you already have two devices on the active devices list.
To replace an active device:
Press MENU/SELECT on the handset when it is not
in use.
Press CID or DIR to highlight Bluetooth, then press
MENU/SELECT.
Press CID or DIR to highlight Paired devices, then
press MENU/SELECT.
Press CID or DIR to highlight a device, then press
MENU/SELECT.
Press MENU/SELECT again to select Connect.
When you already have two cell phones on the active
devices list, the handset shows Maximum of 2 devices
can be connected and then Replace an existing
active device with cellular? Press SELECT.
When you already have one headset on the active
devices list, the handset shows Only 1 headset can be
connected and then Headset A will be replaced from
Active list? Press SELECT.
Press MENU/SELECT. You are prompted to select a device
on the paired devices list.
Press CID or DIR to highlight the device to be
replaced, then press MENU/SELECT. The handset displays
Device removed from active list and then Connecting
Cell Phone A to the base...
Depending on your cell phone settings, you may
need to press a key on your cell phone to confirm the
connection. When you successfully replace and connect
an active device with a paired device, the handset
displays Device connected.
1.
2.
3.
4.
5.
•
•
6.
7.
8.
SELECT DEVICE
1 Cell Phone A
2 Cell Phone B
BLUETOOTH
Add cellular
Add headset
Active devices
Paired devices
Connect
Rename
Remove paired
REPLACE DEVICE
1 Headset A
2 Cell Phone BC
Replace an
existing active
device with
cellular?
Press SELECT
Device removed
from active
devices list
Connecting
Cell Phone A
to the base...
Device
connected