AT&T Trimline TR1909B - Switching from Wall Installation to Desktop

10
11
Getting started
Switching from wall installation to desktop
To return the bracket from wall mount position to desktop use,
follow the instructions below:
Remove the telephone base from the mounting plate. Unplug
the telephone line cord from the telephone wall jack and
remove the cord from the slots under the telephone base.
Lift the handset and place it aside. On the telephone base, pull
out the handset tab and rotate it 180 degrees. Replace the
handset tab back to the groove until it clicks into position.
1.
2.
Remove the bracket
from the base. Hold the
telephone base firmly
and then slide the
bracket downwards as
the arrows indicate.
3. Rotate the bracket to the desktop
installation position. Push the
bracket down as shown below until
it clicks into place.
4.
Follow steps 2-4 in Telephone installation on page 8 to install
your telephone for desktop use.
5.