Atari PONG 4P - Lifting Motor Replacement

PONG 4P D&B Manual
11/18/2019
47
0.04in
Step 2 Utilize Phillips screwdriver to loosen 4 screws to remove the motor from the bracket.
Utilize Allen wrench to loosen 2 screws (turning counterclockwise) to remove the gear from
the motor.
Step 3 Replace with the new motor and install in reverse order.
Note: The distance from motor to gear should be 0.04in(1mm).
Step 4 Refer to 8.8 Belt Tension Adjustment Instruction for X Axles and P1-P4 Axles in the
Manual to test and adjust the belt.
8.9.4 Driver Replacement
Kit List:
Step 1 Locate a driver. Utilize Phillips screwdriver to loosen 2 screws and unplug the
connectors to remove the driver.
Note: It’s the same method on 7 drivers.
Step 2 Replace with the new driver and install in reverse order.
No.
Part No.
Name
Picture
1
P163-477-000
Motor driver
gear