EasyManua.ls Logo

ATB ATB-control 3 - General and Safety Information

ATB ATB-control 3
15 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ATB WATER GmbH, Südstraße 2, D-32457 Porta Westfalica, www.atbwater.com
ATBcontrol
©
3
Control unit for the activation of small wastewater treatment plants of the types AQUAmax
®
BASIC / CLASSIC
and AQUAPRIMO
General and safety information
With intended employment of the equipment no hazards whatsoever emanate from the unit. National applicable
regulations and technical data are to be observed.
Should the ATBcontrol
©
3 be used for other purposes without the express approval of ATB Umwelttechnologien
GmbH and/or if the following safety information is disregarded, this can lead to malfunction of or defects in the
plant. In this case any liability is ruled out.
Modifications to the unit are not permitted and lead to the loss of all claims under warranty.
Do not operate any unit which indicates malfunctions, has been dropped or is damaged in any way.
Features
Microprocessor controlled
USB connection for data readout and input
Splash water protected. Conditionally suitable for outside areas (IP54)
Wall mounting
Voltage failure detection system (UVS
®
)
Potential-free contact for an additional alarm facility
Simple and rapid operation
Times for all parameters completely pre-programmed
Automatic run-in phase with suppression of excess sludge removal
Parameter settings freely selectable
Alarm interval
Alarm volume adjustable
Deployable for AQUAmax
®
BASIC / CLASSIC and AQUAPRIMO
Plug-in
Winter operation and sludge removal mode for the reduction of the aeration times
Assembly
Using the mounting materials provided secure the ATBcontrol
©
3 to the casing provided for this and to a suitable,
as far as possible, weather-protected position.
With temperatures below 0°C a severely limited function of the LC display is to be anticipated.