ATB ATB-control 3 - Pre-Set Parameters

ATB WATER GmbH, Südstraße 2, D-32457 Porta Westfalica, www.atbwater.com
Pre-set Parameters
Type BASIC CLASSIC
[PT] No. Duration Pause Duration ON OFF ON OFF ON OFF
[sec] [h] [min] [sec] [min] [h]
min / max
1
4/10 4/30 1.5 /
2
10/90 5/60 5/20 3/22 0:30 / 15 7:30 / 20 0:30/15
7:30/20
1
00:30 00:30
2 00:30 00:30
4 00:42 00:30
6 00:48 00:30
8 01:00 00:30
10 01:18 00:39
12 01:36 00:48
16 01:54 00:57
20 01:00 00:30
24 01:12 00:36
28 01:24 00:42
32 01:36 00:48
36 01:48 00:54
40 01:54 01:00
44 02:18 01:06
48 02:30 01:12
50
02:42
01:18
Type BASIC CLASSIC BASIC CLASSIC BASIC CLASSIC
[PT] No.
[min] [min] [sec] [sec] [sec] [sec] [sec]
min / max
1
60/120 10/120 0/120 0/120 0/30 0/90 0.2/1.0 0.2/0.5
1
20 0 0
2
20 1 1
4
20 2 2
6
20 3 3
8
20 4 4
10
20 5 5
12 22 6 6
16
29 8 8
20
36 10
24 43 12
28
50 13
32
58 15
36 65 17
40
72 19
44
80 21
48
86 23
50
90 24
1
Minimum or maximum possible input values
2
The maximum time corresponds to the specified time of the aeration phase.
3
With standard conditions. These values can, in practice, vary by +/- 10%.
311
379
120 0.2
0.5
10
30
436
522
622
5
7 2.0
Settling
phase
Water
removal
Run-on time
41
Charging Denitrification
Aeration
phase
Energy consumption³Flushing surge
Aeration
[min:sec] [min:sec]
10 6.0
Sludge removal
Normal operation
Aeration Aeration
10
Economy mode
[kWh/a]
202
270
07:30
07:30
195
1068
943
818
755
1561
1192
1268
1374
1462
The setting of the control system takes place to the above details. The table is saved in the control unit; a manual
input of the individual values is not necessary and at this point serves solely for checking.