ATB WATER GmbH, Südstraße 2, D-32457 Porta Westfalica, www.atbwater.com
Main Level
In the main level you have the possibility, using OK, ↑↓ and OK again, of accessing
various sub-menus, which enables the acquisition of further information, amendment of
settings or moving into manual operation.
You leave the main level through ↑↓ until the point Return and OK.
Logbook
All relevant errors, run times, events and messages are lodged in the logbook.
You access the individual points using ↑↓ and OK.
Errors
Recording of the error messages which have arisen
(max. 1000). An explanation of the indicated messages
can be found in the appendix. Return using OK.
Run times
You can have the run times
shown in a weekly summary and
over the complete operating
time.
Events
Documentation of manual interventions (max. 1000). E.g.
Changes of run times.
Return using OK.
Messages
Every change of status is documented here; e.g. when
the float switch has switched, when the compressor has
switched on and off (also whether automatically or
manually), failure of the mains supply voltage.
Settings
All relevant settings can be reviewed here.
Modifications are, with the exception of the confirmation of a sludge removal and of the
signal tone, are possible in the Service Mode.
Operating parameters
feeding: specification of the feeding time (with the
BASIC the number of charging batches) for the build-up
of the communicating pipe between coarse filter and
sludge activation.
fed. pause: Time period between batches.
Deni phase: Duration of the denitrification phase. The
denitrification phase is component part of the aeration
phase and takes place following the charging.
To Next Page
Loading...