Why does my Atek UPS alarm buzzer beep continuously when the AC supply is normal?
The alarm buzzer may beep continuously on your Atek UPS when the AC supply is normal because the UPS is overloaded. To resolve this, verify that the load connected to the UPS does not exceed the UPS capability specified in the specifications.
Why is the backup time so short on my Atek Blazer Vista 1000 UPS during a power failure?
If the backup time is shortened during a power failure when using your Atek UPS, there are several potential causes: * The UPS might be overloaded. Try removing some non-critical loads. * The battery voltage may be too low. Charge the battery for 10 hours or more. * The battery could be defective due to high temperature operation or improper usage. Consider replacing it with the same type of battery.
What to do if my Atek UPS LCD displays Battery mode when mains are normal?
If your Atek UPS LCD displays Battery mode even when the mains are normal, check the following: * The circuit breaker may be broken. Try resetting it. * The power cord could be loose. Ensure it is properly reconnected.
How to fix communication lost between my Atek UPS and computer?
If communication is lost between your Atek UPS and computer, consider these solutions: * The software may not be installed correctly. Check the software settings. * The cable connection might be faulty. Ensure the RS-232 or USB cable is firmly connected to COM1/COM2 of the computer and confirm the settings again.
How to fix no LED display on my Atek UPS front panel?
If there is no LED display on the front panel of your Atek UPS, the following could be the reasons: * The battery may be missing. Charge the battery for up to 10 hours. * The battery might be defective. Replace it with the same type of battery. * The input cord isn’t electrified, and the power switch isn't pressed. Press the power switch again or electrify the input cord.
General| Capacity | 1000VA / 600W |
|---|---|
| Frequency | 50/60Hz |
| Communication Interface | USB |
| Operating Temperature | 0°C to 40°C |
| Storage Temperature | -15°C to 45°C |
Overview of the front panel components and their functions.
Overview of the back panel ports and connectors.
Procedures for inspecting and placing the UPS unit.
Instructions for charging the UPS battery before use.
Connecting computer-related devices to the UPS outputs.
Connecting internet and phone lines to the UPS.
Connecting a serial cable for unattended system shutdown.
Procedure for powering the UPS unit on and off.
Explanation of UPS LCD display readings and indicators.
Understanding the load level indicators on the UPS display.
Understanding the battery capacity indicators on the UPS display.
Steps to download and install the WinPower monitoring software.
To Next Page
