ATEL WB550 Apex by ATEL
User Manual
V2.3, July 20, 2023
with minimum obstruction to carrier cell towers will result in a better
data throughput.
b. Yo u c a n l o g i n t o t h e W e b G U I t o c h e c k t h e R S R P / R S R Q / S I N R t o v e r i f y
the changes to signal quality.
c. In the WebGUI, you can also go to “Settings” > “Cellular Settings” >
“Network”, to specify the band you want to use. Please check and
confirm band information with your carrier before you adjust the band
you prefer. Please note that we don’t encourage customers to adjust
these features by themselves if you are not familiar with mobile
technology.
Regulatory Statements
FCC Equipment Authorization ID: XYO-WB550
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
! This device may not cause harmful interference.
! This device must accept any interference received, including interference that may
cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation.
FCC CAUTION: Any changes or modification not expressly approved by ATEL, the party
responsible for compliance could void the user's authority to operate this equipment.
This equipment generates uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
To Next Page
Loading...
Need help?
General
