ATEL WB550 Apex by ATEL
User Manual
V2.3, July 20, 2023
3. Configuring the Router
You can login to the WebGUI by following the instructions below. Once logged in,
you can configure the device settings according to your requirements.
1. Connect your PC to the WB550 Router using the Ethernet cable. Use either
of the two Ethernet ports on the router.
2. Power on the Router and wait for about 40 seconds (until it finishes
initializing).
3. Please ensure that a USIM card has been inserted into the USIM slot in the
device and login to the WebGUI as instructed in section 3.1 Login (below).
4. Note: You can also connect your PC to the router via WiFi. Connect to the
WB550 WiFi (as you would any WiFi) and input the WiFi SSID and the
accurate password as shown on the device label to connect.
3.1 Login
1. Open your Web browser and enter 192.168.0.1 in the address bar. The login
window will popup.
2. When prompted for the Username and password, enter the following:
a. Username: admin
b. Password: Unique to your device, check the device label for your
password.
3.2 Dashboard
After successfully logging in, the screen below will appear and you will see four
main menus on the top bar of the WebGUI.
To Next Page
Loading...
Need help?
General
