ATG429EBPOperationManual
3‐4
June4,2015
Rev.A2
3.2 CONTROL FUNCTIONS
3.2.1 429EBP CONTROLS AND INDICATORS
(1) TRAP Mode Key IN RX MODE:
Start/Stop/Off control for the TRAP mode.
Pressing `ENT' key for any of the prompted
parameters will cause a don't care to be used for
that parameter. Data is automatically protected if
unit is powered off when TRAP is on.
IN TX MODE:
On/Off key for TX data PROTECT mode. If
Protect is on the Transmit parameters will be
protected when the 429EBP is powered off.
(2) AUTO Mode Key
IN RX MODE:
On/Off key for `AUTO' scrolling mode. Allows the
operator to scroll through labels that have been
received by TRAP mode. AUTO mode steps
`Automatically' through the word buffer and
displays the number of trapped words as well as
the engineering name of the label, if it is in the
`Label' mode. If in the `Data' mode, the AUTO
mode steps to the same data screen for the next
trapped word. Scroll keys will allow scanning
direction to be selected.
IN EDIT MODE:
While in the EDIT mode, this key allows the
hexadecimal value `C' to be entered.
(3) TX Parity Switch
Allows operator to select ODD or EVEN
transmission parity.
(4) TX SPEED Switch
Allows operator to select HI (100 kbps) or LO
(12.5 kbps) transmission rate.
(5) TX Output Port
Allows access to transmitter port using standard
3-conductor, 1/4" phone plug.
(6) RX Input Port
Provides input to receiver port using standard 3-
conductor, 1/4" phone plug.
(7) SCROLL Keys
Allows operator to scroll through display
menus (10 transmitter slots, up to 8192 receiver
slots, or data menus). Allows selection of the
scanning direction in AUTO mode. If editing data
of an ISO Alpha label (356 or 357), the SCROLL
keys will allow selection of the Alpha character to
be entered (SCROLL to the desired character and
press `ENT' to select a character).
NOTE: See EDIT/DEL key also.
(8) TX/RX Indicator
LED indicates that the system is in either the
transmitter or receiver mode of operation for
display and entry of data.
To Next Page
Loading...