ATG 429EBP - Page 17

ATG429EBPOperationManual

3‐7
June4,2015
Rev.A2

(21) EQID Key IN EDIT MODE:
While in the EDIT mode, this keys allows the
hexadecimal value `E' to be entered.
NON EDIT MODE:
While in any mode other than edit mode pressing
this key will `Pop Up' the `EQPMT ID' (Equipment
Identifier) screen. This may than be edited using
the normal edit procedure. Up to 3 hex characters
may be entered. Pressing this key again or any
other mode control key will clear this screen.
The Equipment Identifier is used by the 429EBP
to determine which ARINC definition to use for
the received and transmitted labels when
displaying and entering data.
(22) FILT Key IN EDIT MODE:
While in the EDIT mode, this key allows the
hexadecimal value `F' to be entered.
IN RX NON-TRAP MODE:
On/Off control for the FILTER mode.
IN RX TRAP MODE:
If in trap mode and the trap has not yet filled to
capacity, this key activates the CONTinuous
TRAP mode. Pressing this key a second time will
cause the trap to close on the words currently
held in the trap buffer.
(23) SINGLE SHOT Key IN NON-EDIT MODE:
Activates transmission of any TX words that have
been set to 1ms word rate (SNGL SHOT).
IN EDIT MODE:
While in the EDIT mode, this key allows the
hexadecimal value `B' or the '-' (ENG mode) key
to be entered.