Ather Dot - Cleaning; Monthly Checks; The Dos & Don’ts

2019
Monthly checks
Test PRCD using its Test Button at least once a
month. Press the Test Button to check if PRCD
cuts-o power from the Ather Dot™. In case
power doesn’t cut o, please contact customer
support.
Note: Press the Reset Button to restore Ather Dot™,
right after you have checked the PRCD Test Button.
Ensure that the charging cable is always well
secured, so that it’s never stepped on, driven
over, tripped on, or undergoes any damage
or stress.
Always turn o the Ather Dot™ when not plugged
into the vehicle.
Make sure the Ather Dot™’s air flow is never
blocked to ensure its proper functioning.
The Dos & Don’ts
Do not use cleaning solvents to clean any part or
component of the Ather Dot™.
The facade of the Ather Dot™, charging cable,
and the connector end of the charging cable
should be regularly wiped with a clean, dry cloth
to prevent accumulation of dirt and dust.
Cleaning
Warning!
Unplug the power cord before cleaning the
Ather Dot™.
Do not use any chemicals to clean the
Ather Dot™. Never spray any liquid onto the
charger handle or wall plug.
Store the charger handle in the dock to
prevent unnecessary exposure to moisture and
contamination.
Never submerge the Ather Dot™’s handle or wall
plug in any kind of liquid.