CATALYST Software Suite
3-3
Dynamic Display Reassignment
You can change the assignment of your Primary and
Secondary display on the fly, without rebooting.
However, before you can change the assignment of the
Primary display, at least one Secondary display must
be enabled, and Extended Desktop mode must be
enabled.
To enable a Secondary display see Enabling /Disabling
Secondary Display on the previous page.
To enable Extended Desktop Mode see Enabling
Extended Desktop Mode on the previous page.
1. Access the Windows
®
Control Panel. Double-click
Display.
2. Click the Settings tab and then the Advanced...
button.
3. Click the ATI Displays tab.
The ATI Displays tab shows you the display(s) that are
active. The Primary display has the button depressed.
To change the display assignment, click the Primary
display’s button or click the button of the other
display device. In Windows
®
2000 clicking the button
will reassign the Primary and Secondary monitors.
Clicking the button creates a clone or mirror image of
the Primary display onto the Secondary display. Clicking
the button extends your desktop to a Secondary
display located to the right of the Primary display.
To Next Page
Loading...
Need help?
General
