4) Turbo mode
6
6
This is the mode that enables the appliance to be put into 2 hours of timed Forced Operation (without
any regulation) to increase the room’s temperature quickly.
a) Leave the switch
on the Marche position.
b) Press the command
, the indicator
and
lights.
The TURBO mode can be interrupted manually before the end of the time set. In order to do this, press
the command
again.
NB: On a piloted or independently programmed appliance, only the Stop and Anti-frost instructions have
priority when the TURBO mode is activated (the other instructions are ineffective).
5) How to lock the temperature wheel ?
It is possible to lock the knob
, preventing untimely handling of the device (children…).
a) Set the knob to the position required.
b)Use a screwdriver to release the screw provided on the control box (1).
c) Screw in until the toothed wheel’s shaft (2) is locked.
- Prevent children from climbing on the device.
- Any intervention on the electrical parts must be performed by skilled staff.
- Do not insert objects or paper in the device.
-
Upon first warming,
a slight smell ma
y a
ppear
,
due to the evacuation of compounds used during the
de
vice’
s man
ufacturing.
- The casing may be hot, even when the device is off.
WARNING
- To maintain the performance of the device, about twice per year, clear the dust.
Do not use abrasive products.
- You are recommended to have the appliance and the amount of fluid checked by a professional technician
after 6 years of use and replace it if necessary.The amounts of fluid to be introdued into the appliances
are for 500W models 3,65 litres and for 750W models 5,45 litres.
- Any deteriorated fluid must necessarily be disposed of at a waste oil collection station.
MAINTENANCE
1
2
RECOMMENDATIONS OF USE
- When ventilating the room, stop the device by setting the switch
to the Arrêt position.
- If you leave for several hours, lower the temperature.
Leaving for:
Less than 24 hours :do not touch the controls.
More than 24 hours or during summer :set the temperature knob to .