Do you have a question about the Atlantic Alfea hybrid duo gas Series and is the answer not in the manual?
Details on how the unit is packaged, including outdoor and hydraulic units.
Lists optional accessories like 2-circuit kits and room thermostats.
Describes the intended uses and functions of the heat pump.
Defines key terms such as Split, Air/water, Inverter, and Hybrid.
Outlines rules for installation and maintenance compliance with regulations.
Procedures for receiving and checking the appliance upon delivery.
Importance of preventing contamination in refrigerant circuits for reliability.
Lists accessories included with the external and hydraulic units.
Instructions for connecting refrigerant pipes, respecting diameters and distances.
Precautions and guidelines for installing the outdoor unit.
Recommendations for optimal placement of the outdoor unit regarding clearance and snow.
Instructions for connecting the condensate drain hose and preventing icing.
Guidelines for installing the indoor hydraulic module.
Requirements for the chimney evacuation pipe system.
Guidelines for connecting the chimney pipe, including adaptors.
Requirements for sealed pipe connections for air intake and exhaust.
Pre-commissioning checks required before starting the unit.
How to set heating pump speed for optimal performance.
Settings for the gas exchanger pump speed.
Checks and procedures for the gas circuit.
Checks and procedures for the electric circuit.
Step-by-step guide to commissioning the heat pump.
Procedure for starting the gas generator for combustion checks.
How to adjust combustion parameters after a gas check.
Overview and operation of the user interface and control units.
Explanation of the water logic control system and its settings.
How faults are displayed on the hydraulic module's interface.
Error codes and their meanings for single-phase outdoor units.
Error codes and their meanings for three-phase outdoor units.
Information available through the 'Info' button.
Maintenance procedures for the gas heat exchanger.
How to check the hydraulic circuit for leaks and pressure.
Maintenance of the evacuation pipe system.
Maintenance procedures for the hot water tank.
Checks to perform on the outdoor unit.
Inspecting and tightening electrical connections.
Procedures for checking combustion parameters.
Steps to drain the hydraulic module.
Explanation of the directional valve functions.
How to check the ACI (anti-corrosion protection) system.
A checklist for commissioning the heat pump.
Step-by-step procedure for starting the heat pump.