To Next PageTo Next PageWhat to do if there is an outside unit connection error in Atlantic Heat Pump?
If your Atlantic Heat Pump shows an outside unit connection error, especially during the start phase, refer to the "Start-up" paragraph.
General| Type | Air-to-water heat pump |
|---|---|
| Energy Efficiency Class (Heating) | A++ |
| Refrigerant | R410A |
| Operating Temperature Range (Heating) | -20°C to +35°C |
| Integrated Domestic Hot Water Tank | Yes |
| Operating Temperature Range (Cooling) | 10°C to 46°C |
Details the items included in the heat pump package.
Explains key terms like Split, Air/Water, Inverter, and COP.
Lists technical data including heating output, power absorbed, and electrical characteristics.
Covers site selection, clearances, positioning, and condensate drain for the outdoor unit.
Details installing the hydraulic unit, refrigeration, and hydraulic connections.
Explains electrical supply characteristics, wiring, and connections for outdoor and hydraulic units.
Guides through the initial startup, settings, and configuration of the system.
Describes the display, buttons, and controls of the user interface and thermostats.
Explains temperature adjustments, heating curves, and parameter settings.
Details how to navigate and adjust system parameters and recommended settings.
Lists error codes, messages, and diode flashing patterns for troubleshooting.
Details hydraulic checks, DHW tank maintenance, and unit checks.
Covers emptying the hydraulic unit, distribution valve, and ACI check.
