What to do if I see 'HP outgoing flow sensor error (T5)' on my Atlantic Loria Duo 6000 R32?
If your Atlantic Heat Pump displays a 'HP outgoing flow sensor error (T5)', it typically means there's a short circuit, the sensor is disconnected, cut off, or the sensor is defective. You should check the sensor connections and replace the sensor if necessary.
What to do if I see 'HP return flow sensor error (T6)' on my Atlantic Heat Pump?
If your Atlantic Heat Pump displays a 'HP return flow sensor error (T6)', it typically means there's a short circuit, the sensor is disconnected, cut off, or the sensor is defective. You should check the sensor connections and replace the sensor if necessary.
What to do if I see 'Circuit 2 sensor error (T12)' on my Atlantic Heat Pump?
If your Atlantic Heat Pump displays a 'Circuit 2 sensor error (T12)', it typically means there's a short circuit, the sensor is disconnected, cut off, or the sensor is defective. You should check the sensor connections and replace the sensor if necessary.
What to do if I see 'Outdoor temperature sensor error (T7)' on my Atlantic Loria Duo 6000 R32?
If your Atlantic Heat Pump displays an 'Outdoor temperature sensor error (T7)', it typically means there's a short circuit, the sensor is disconnected, cut off, or the sensor is defective. You should check the sensor connections and replace the sensor if necessary.
What to do if I see 'DHW tank sensor error (T8)' on my Atlantic Loria Duo 6000 R32?
If your Atlantic Heat Pump displays a 'DHW tank sensor error (T8)', it typically means there's a short circuit, the sensor is disconnected, cut off, or the sensor is defective. You should check the sensor connections and replace the sensor if necessary.
How to fix low hydraulic flow rate in my Atlantic Loria Duo 6000 R32?
If the hydraulic flow rate is too low in your Atlantic Heat Pump, it could be due to circulation pump speed settings being too low, or a clogged filter valve. To resolve this, increase the circulation pump speed settings and clean or replace the clogged filter valve.
What causes communication error in Atlantic Loria Duo 6000 R32 and how to solve it?
A communication error between the interface board and the HP regulator board in your Atlantic Heat Pump suggests a wiring issue. Inspect and fix the wiring connections to resolve this.
Why is the initial temperature (T5) or return temperature (T6) < 2°C on my Atlantic Heat Pump?
If the initial temperature (T5) or return temperature (T6) is less than 2°C in your Atlantic Heat Pump, it could be due to a defective frost protection function or a disconnected back-up. Inspect and repair the frost protection function and reconnect the back-up.
What to do if I see a legionella cycle error on my Atlantic Heat Pump?
A Legionella cycle error in your Atlantic Heat Pump may occur if the DHW back-up is disconnected. Reconnect the DHW back-up to resolve this issue.
What causes frost on the return circuit during defrosting of my Atlantic Loria Duo 6000 R32?
If frost is detected on the return circuit when defrosting the outdoor unit (temperature < 2°C) in your Atlantic Heat Pump, it indicates that the circulating water volume is too low. Increase the circulating water volume to address this.
To Next Page
General