Atlantic O’Pro 272014 - Electric Connection

6
result of both water expansion during heating and also pressure
uctuations.
The supplied PTR valve must be tted with Teon tape. Do not use paste
or hemp.

DN15 copper drain lines must be connected to the discharge pipe of the
PTR valve. The copper drain line must fall away from the ESWH and
be installed in a frost- free environment.
The termination point of a drain line must comply with the requirements
of AS/NZS 3500.4

WARNING: The Pressure Temperature Relief valve and drain line must
not be sealed or blocked.
Electric Connection
All electrical work must be carried out by a registered electrician and in
accordance with AS/NZ 3000.
The Atlantic ESWH must be lled with water before connection to a
power supply.
Switch o the power before removing the cover to avoid any risk of injury
or electric shock.
The installation must be equipped, upstream of the appliance, with
a bipolar cut-out device (fuse, breaker switch) respecting local
regulations (30 mA earth-leakage breaker).
Always connect the earth conductor of the cable to the earth ground
wire or connect the earth conductor to the appropriate terminal
identied by the symbol.