How to fix the Atlantic SOKIO control unit screen if it does not come on?
If the control unit screen on your Atlantic Heater doesn't turn on, ensure the switch on the back or side of the device is in the 'I' position. Also, verify that the heater is properly connected to the electrical system.
Why does dirt appear on the wall around my Atlantic Heater?
If you notice dirt on the wall around your Atlantic Heater, it's likely due to poor ambient air quality caused by pollutants like cigarette smoke, candles, incense, or fireplaces. Ensure the room is properly ventilated with adequate ventilation and air inlets.
Why is the Expert mode menu not accessible on my Atlantic Heater?
To access the Expert mode menu on your Atlantic Heater, you must enter the correct PIN code.
What to do if Atlantic SOKIO Heater heats up continuously?
If your Atlantic Heater is heating continuously, first check for drafts (from open doors or cable covers) and ensure the temperature setting hasn't been unintentionally altered. A problem in the electrical network may also be the cause. As a solution, try cutting the power to the heater (fuse or circuit-breaker) for about 10 minutes, then turn it back on. If this reoccurs, have your power supply checked by your power distributor.
Why does the ambient temperature differ from that displayed on my Atlantic Heater?
Allow at least six hours for the temperature to stabilise on your Atlantic Heater. A difference of up to 0.5°C between the ambient temperature and the displayed temperature is normal. If the difference is greater, refer to the «Expert mode menu» «T° Calibration» chapter.
General| Frequency | 50 Hz |
|---|---|
| Heating power | 2000 W |
| Functions | Overheat protection |
| Mounting | Wall-mounted |
| Power | 2000 W |
| Voltage | 230 V |
| Heating Area | Up to 20 m² |
| Safety Features | Overheat protection |
To Next Page
