Product information EN ETD STR61-70-13
6
© Atlas Copco Industrial Technique AB - 9839 0180 01
Country of origin
Please refer to the information on the product label.
Dimensional drawings
For information about the dimensions of a product, see the Dimensional drawings archive:
http://webbox.atlascopco.com/webbox/dimdrw
Overview
The Tensor system
The Tensor system consists of a range of tightening tools powered by brushless electric motors and differ-
ent drive units.
Motors are available in different sizes. All tools are protected from overheating of the motor. Electrical pro-
tection system is based on an earth fault circuit brake, Earth Fault Protector (EFP). The EFP senses small
current leakage (>30mA) and if leakage occurs, the drive is switched off (30ms). Changing, interfering or
tampering with the protection system voids all warranty and obligations from Atlas Copco. Trouble-shoot-
ing and re-start of the system may only be carried out by an authorized person. Check the function of the
EFP on a regular basis by pressing the trip-button. The EFP should switch off accordingly.
Technical data
Ordering No 8436626070
Model ETD STR61-70-13
Model type Straight
Distance center to side 26.5 mm
Speed 560 r/min
Length 491 mm
Torque range 15–80 Nm
Torque range 12–58 ft lb
Square drive 1/2 in
Weight 2.3 kg
Weight 5.1 lb
Height - mm
Motor power 1500 W
Motor voltage 200 V
Motor voltage type 3 a.c.
RFID chip
The tool has an embedded RFID chip which stores information about the product. The chip is located on
the motor of the tool. With an RFID reader it is possible to read and write information to the chip.
To Next Page
Loading...
