Parameter
screens
Designation Related topic
<P.8> Pressure unit See section Calling up/modifying unit of
pressure
<P.9> Automatic Restart After Voltage Failure
(only for Atlas Copco)
See section Activating automatic restart
<P.10> Selection between Y-D or DOL starting See section Selection between Y-D or DOL
starting
<P.11> Load delay time See section Calling up/modifying load
delay time
<P.12> Minimum stop time See section Calling up/Modifying minimum
stop time
<P.13> Setting a password See section Activating password protection
<P.14> Remote pressure sensing See section Activate Load/Unload remote
pressure sensing.
<P.15> Y-D time Indicates the time (s) between Y and D.
<P.16> Number of motor starts per day Limits the maximum number of starts per
day.
<P.17> Unload to stop time Defines the time the compressor must run
unloaded before it can stop.
Parameters <P.15>, <P.16> and <P.17> are only reachable after entering a code. Contact Atlas Copco.
Protections
screens
Designation Related topic
<Pr.2> Protections screen See section Calling up/modifying protection
settings
Test screens Designation Related topic
<t.1> Display test See section Test screens.
<t.2> Safety valve test See section Test screens.
Instruction book
34 2920 7140 90
To Next Page
Loading...
