Instruction book
1904 0504 83
ϭϭϭ
The display (2) will show a service message if a service plan interval has been exceeded or if a service
level for a monitored component has been exceeded. Carry out the service actions of the indicated plans
or replace the component and reset the relevant timer, see section Service warning.
ô õ
ø õ ý ÷ ü
ù ý
ý ù
ø õ
õ
ø ü ÷
î ë ÿ ï
î ï
Press stop button (9). Automatic operation LED (8) goes out and the
compressor stops after 30 seconds of unloaded operation.
'
ë ð
ë í
(
ï ÿ ë ì í î ï ð ð ë î
(
ï ï
ï
ë
ò
ï ì ï î
ï
ÿ
l
press emergency
stop button (10). Alarm LED flashes (7).
On compressors with an Elektronikon® Graphic controller:
Remedy the fault and unlock the button by pulling it out.
Navigate to the Stop icon on the display by means of the navigation keys
(3/4) and press the Select key.
Press reset.
þ
ë
ë
ð ï ï ì ï î
ï
ÿ
ð
ë í
*
ë
A m n B
ë î
ë î ì ò ó ð
ë í í
See also
Close air outlet valve (AV), see section Introduction.
)
ò
ï î
ÿ ë ë ó ï
ÿ ë ì í î ï ð ð ë î ð
+
Close the cooling water inlet valve.
If freezing temperatures can be expected, drain the cooling system
completely.
To Next Page
Loading...
