Atlas Copco GA 37 VSD - Air Filter and Oil Filter Change

Instruction book



1904 0504 83 ϭϭϳ

. ï  ï î ò ó
Keep the outside of the electric motor clean for efficient cooling. If necessary, remove dust with a brush
and/ or compressed air jet.
 ï ò î    ì ò    ï  ò  ÿ ï
The bearing at the non-drive end side is greased for life.
The bearing at the drive end side is lubricated by the oil system.
,
ë ÿ ò   ë  ë  ò  î   ó  ï î

ï ÿ ë ì ì ï   ò   ë  ð
1. Never remove the element while the compressor is running.
2. For minimum downtime, replace the dirty element by a new one.
3. Discard the element when damaged.

î ë ÿ ï   î ï
1. Stop the compressor. Switch off the voltage.
2. Release the snap clips of air filter (AF) and remove the cover and the air filter element.
Discard the filter element.
3. Fit the new element and the cover.
4. Reset service indicator (VI) by pushing the knob in the extremity of the body.
5. Reset the air filter service warning.
For compressors equipped with an Elektronikon® Graphic regulator, see section Service
menu.