ϭϮ
1904 0504 83
e
<
]
< ; 7
]
; 7 7
? >
B A 7 : ; 9 < ; 7 R < 8 S ; 9 P
d
< ; 7
@
8
? ?
\ <
c > ?
8 9 O U ; P U
> ? @
< S 6
? >
B B <
?
:
>
S 6
> ?
8 : A
? >
B : U 8 :
@
< A 7 O
? >
B A 7 : ; 9 R ;
? >
W
E E D
Replace all consumables at recommended service intervals or sooner if operating conditions
several / warrant or replace every 12 months.
E F D
Make sure that all sound –damping material, e.g. on the bodywork and in the air inlet and outlet
systems of the compressor, is in good condition. If damaged, replace it by genuine material to
prevent the sound pressure level from increasing.
E G D
Every time the separator element is renewed, examine the discharge pipe and the inside of the
oil separator vessel for carbon deposits; if excessive, the deposits should be removed.
E
H
D
Before clearing the machine for use after maintenance or overhaul, check that operating
pressures, temperatures and time settings are correct and that the control and shut-down
devices function correctly. If removed, check that the coupling guard of the compressor drive
shaft has been reinstalled.
f g h
X U
>
R < 7 7 <
]
; 9 P B 8 R
>
: \ 6
? > @
8 A : ; < 9 B 8
? >
B :
? >
B B
>
O
]
U
>
9 U 8 9 O 7 ; 9 P
? >
R
?
; P
> ?
8 9 : i
a. Never inhale refrigerant vapours. Check that the working area is adequately ventilated; if
required, use breathing protection.
b. Always wear special gloves. In case of refrigerant contact with the skin, rinse the skin with
water. If liquid refrigerant contacts the skin through clothing, never tear off or remove the
latter; flush abundantly with fresh water over the clothing until all refrigerant is flushed away;
then seek medical first aid.
c. Always wear safety glasses.
N < <
?
S 8 ; 9 :
>
9 8 9
@ >
<
?
A B
>
< R 9 < 9 j P
>
9 A ; 9
>
6 8
?
: B
]
; 7 7
@
8 A B
> > V
A ; 6 S
>
9 : R 8 ; 7 A
? >
8 9 O 6 < B B ; T 7 \
? >
B A 7 : ; 9 R ;
? > d
E
J
D
All regulating and safety devices shall be maintained with due care to ensure that they function
properly. They may not be put out of action.
E K D
Customer to check all the safety / protection devices once in a month, Check function of
following components and maintain the record of the same.
• Overload relay - set at min setting and check trip+ manual trip
• Safety valve - raise the pressure and check the opening at set press - even Elektronikon
have SV test function.
• Temp switch - open the contacts (make NO) and check trip.
• PSR - reverse any 2 phase and check the trip.
Also consult following safety precautions: Safety precautions during
installation
and Safety precautions during operation.
These precautions apply to machinery processing or consuming air or inert
gas. Processing of any other gas requires additional safety precautions
typical to the application which are not included herein.
Some precautions are general and cover several machine types and
equipment; hence some statements may not apply to your machine.
To Next Page
Loading...
