Figure 39 Motor coupling half position - GVS 300A
1. 18 Nm* 2. Never seize for anti-fretting corrosion
3. Lock ring in contact with end of shaft 4. Never seize for anti-fretting corrosion
1. 18 Nm* 2. Never seize for anti-fretting corrosion
3. Lock ring in contact with end of shaft 4. Never seize for anti-fretting corrosion
* Glued with LOCTITE 243
Motor installation instructions for GVS 200A
1. Place a suitable container under the pump to collect the draining oil. Remove
the drain plug.
Drain the pump.
2. Remove the pump coupling housing, disconnect the finned oil cooler and
unscrew the two connectors (1 on oil casing and 1 on tube) as explained in
the following steps:
A. Remove three screws securing coupling housing. Remove coupling
housing.
Installation
12/2021 - ©Atlas CopcoPage 606996022430_C
To Next Page
Loading...
