Atlas Copco PHE 24 Series User Manual

Detailed steps for dismantling the SDS-Plus reception.

Detailed steps for dismantling the FIXTEC reception.

Steps to remove the gear housing, including model-specific notes.

Procedure for the safe removal of the spindle assembly.

Method for detaching the striker from the tool.

Procedure for removing the inner locking ring for older models.

Procedure for removing the inner locking ring for newer models.

Steps to dismantle inner parts of the spindle.

Procedure for removing the back gear shaft and cylinder.

Steps for dismantling the back gear shaft.

Steps for dismantling the tool's handle assembly.

Procedure for removing electrical components.

Steps to remove the armature from the motor housing.

Procedure for removing the field from the motor housing.

Recommendations for regular tool maintenance and part exchange.

Torque values for key assembly screws.

Detailed lubrication chart with part names, grease types, and quantities.

Guidelines for cleaning parts, with specific attention to bearings.

Instructions for checking parts for abrasion and necessary exchange.

Requirement for an electrical test before reassembly.

Steps for mounting the field into the motor housing.

Procedure for inserting and securing the armature.

Steps for installing carbon brushes, covers, and connecting wires.

Steps for reassembling the tool's handle and covers.

Procedure for assembling parts onto the back gear shaft.

Steps for integrating the back gear shaft and cylinder.

Procedure for assembling inner parts of the spindle.

Steps for assembling the outer parts of the spindle.

Procedure for fitting the spindle and gear components.

Steps for attaching the gear housing to the end shield.

Steps for reassembling the SDS-plus reception.

Steps for reassembling the FIXTEC reception.

Final procedures for testing the tool after assembly.