Atlas Copco PHE 24 Series - Spindle and Gear Shaft Dismantling; Spindle Inner Parts Removal; Back Gear Shaft and Cylinder Removal; Back Gear Shaft Dismantling

PAGE
4
Repair Instruction No. 169.2/94
PHE 24/26/30-Range
Dismantling the
spindle
(inner parts)
PHE 24 R
PHE 26 R
Dismantling the
spindle
(inner parts)
PHE 24 RX
PHE 26 R
PHE 30 RX 2
Removing the
back gear shaft
and the cylinder
Dismantling the
back gear shaft
09/97
1
7
8
65432
132 4 5 6
987
1 Press the following parts from the spindle:
– washer (6)
– pressure sleeve (5)
– plunger (4)
– brake disk (2) (is pressed in).
2 Remove the O-rings (3) and (7).
1 Remove the tumble drive (4) and the
cylinder (1).
2 Press out the bolt (2) by hand and remove
the two disks (3) (older machines: guide
ring (see box).
3 Remove the needle bearing (5) with aid of
an interior extractor. In case of older
machines, remove the 13 rollers (6) from
the back gear shaft.
1 Press the following parts from the spindle:
– washer (9)
– pressure sleeve (6)
– plunger (5)
– brake disk (4)
– pressure sleeve (3) (is pressed in).
2 Remove the O-rings (2), (7) and (8).
9
08/96
09/97
1
2 3
1 2 3 4 56 7
10
8
5
6
7
1 Remove the ring (8).
2 Press off the back gear wheel (7).
3 Remove the remaining parts from the back
gear shaft (1):
– tumble drive (6)
– washer (5)
– coupling box (4)
– spring (3)
– washer (2)