PAGE
12
Repair Instruction No. 174.3/95
PHE 26 RA
1 Fit the gasket (2) to the motor housing (3).
2 Fasten the gear housing (1) to the motor
housing (3) and fix it with screws (2,5+5
Nm).
3 Fit the gear lever (4) (mount it in
the "hammer" position, the pin must
grasp the elongated hole of the locking
slide).
Mounting the
gear housing
1 Insert the spring (8) and the retaining
disk (7).
2 Depress the retaining disk (7) and insert
the ball (6).
3 Fit the retaining ring (5) and the sliding
sleeve (4).
4 Depress the sliding sleeve and insert the
seal ring (3) into the pass.
5 Fit the spacer (2).
6 Push down the sliding sleeve and fit the
rubber (1).
Mounting the
SDS-plus
Reception
Carry out a test run and check for strange noises.
Carry out an electrical examination. (See chapter Electrical and Mechanical Test Instruction).
Test run and
electrical
examination
14
4
1
3
2
12 5
3 4 786
1
5
To Previous Page
Loading...
