Atlas Copco PHE 26 RA - Page 7

PAGE
7
Repair Instruction No. 174.3/95
PHE 26 RA
At each maintenance the tool must be lubricated as shown in the lubrication chart. After having
dismantled the entire tool remove the used grease completely and replace it by new grease. Please
pay attention to the following lubrication chart:
Lubrication
Bauteil Bezeichnung Fettart Menge
A Spindle wheel toothing Darina 5g
B Hollow of back gear, spindle sleeve Darina 14g
D Toothing of back gear Tivela 8g
E O-rings Darina 1g
F Needle bearing Darina je 1g
G Porous bearing boring Darina 1g
H Spindle sleeve thrust bearing Tivela 1g
I Plunger outside Tivela 0,5g
K Cylinder inside Tivela 2g
L Spindle sleeve outside Darina 2g
M Cylinder outside Darina 2g
N Cylinder bolt Darina 0,5g
O Striker Darina 0,5g
P Tumble drive boring Darina 0,5g
Q Gear sleeve inside and outside Darina 4g
S Ratchet/spindle wheel Darina 1g
T Sealing sleeve Darina 0,5g
U Driving tenon Darina 0,5g
V Pinion reception Darina 1g
The service set contains tubes with grease (Tivela, Darina). All items listed above bust be lubricated with
the stated amount of grease. With the remainder of the Darina-tube evenly lubricate the gear box and the
spindle sleeve.
Before assembly submit all relevant parts to an electrical test (see chapter Electrical and Mechanical
Test Instruction).
Electrical test
A
Q
E
E
E
H
I
S
K
M
N
F
V
U
T
F
D
B
P
O
L