:#&&:#5&&:#*5&&
24
#
+4
(+.6'4
'0)+0'
%1/24'5514
/
#+0
2#465
Fig. 5.2 Air filter
1 Snap clips
2 Dust trap
3 Safety cartridge (option)
4 Filter element
5 Filter housing
6 Vacuator valve
4
'%1//'0+105
New elements must also be inspected for tears or punctures before
installation.
Discard the element (4) when damaged.
In heavy duty applications it is recommended to install a safety
cartidge which can be ordered with
part no.: 2914 9311 00
A dirty safety cartridge (3) is an indication of a mal-functioning air
filter element. Replace the element and the safety cartridge in this case.
The safety cartridge cannot be cleaned.
%
.'#0+0)
6*'
&756
64#2
To remove dust from the dust trap pinch the vacuator valve (6) several
times.
4
'2.#%+0)
6*'
#+4
(+.6'4
'.'/'06
1. Release the snap clips (1) and remove the dust trap (2).
Clean the trap.
2. Remove the element (4) from the housing (5).
3. Reassemble in reverse order of dismantling.
4. Inspect and tighten all air intake connections.
5. Reset the vacuum indicator (Fig. 5.3).
Fig. 5.3 Vacuum indicator
7 Air filter contamination indicator
8 Reset button
9 Yellow indicator
#
+4
4'%'+8'4
The air receiver is tested according to official standards. Regularly
have inspections carried out in conformity with local regulations.
5
#('6;
8#.8'
Following checks must be carried out:
– a check of the opening of the lifting gear, twice a year.
This can be done by screwing the cap of the valve anti-clockwise.
– a check of the set pressure once a year according to the local
regulations. This check cannot be done on the machine and must
be carried out on a proper test bench.
7KH$WODV&RSFRDLUILOWHUV DUHVSHFLDOO\ GHV LJQHGIRU
WKHDSSOLFDWLRQ7KHXVHRIQRQJHQXLQHDLUILOWHUVPD\
OHDGWRVHYHUHGDPDJHRIHQJLQHDQGRUFRPSUHVVRU
HOHPHQW
1HYHUU XQWKHFRP S UHVVRUZLWKRXWDLUILOWHUHOHP HQW
To Next Page
Loading...
