Table of Contents
ii
4.3.1.4 EEPROM .....................................................................................4-3
4.3.2 "Fuses" Settings .................................................................................4-3
4.3.3 “Lock Bits” Settings.............................................................................4-5
4.3.4 “Advanced” Settings ...........................................................................4-6
4.3.4.1 Signature Bytes............................................................................4-6
4.3.4.2 Oscillator Calibration Byte............................................................4-6
4.3.4.3 Reading Oscillator Calibration Byte .............................................4-6
4.3.4.4 Writing Oscillator Calibration Byte................................................4-6
4.3.5 “Board” Settings..................................................................................4-6
4.3.5.1 Oscillator......................................................................................4-7
4.3.5.2 Revision .......................................................................................4-7
4.3.6 "Auto" Settings....................................................................................4-7
4.3.6.1 Setting up the System for Auto Programming..............................4-8
4.3.6.2 Logging the Auto Programming to a File......................................4-8
4.3.7 History Window...................................................................................4-8
Section 5
Command Line Software ......................................................................5-1
5.1 Parameters: ..............................................................................................5-1
5.1.1 Sample Usage....................................................................................5-3
Section 6
Special Considerations.........................................................................6-1
6.1 Fuse Programming ...................................................................................6-1
6.2 RESET Used as General IO Port..............................................................6-1
6.3 AVR Devices with no ISP Option ..............................................................6-1
6.4 Devices without RC Oscillator Calibration ................................................6-1
Section 7
Troubleshooting Guide .........................................................................7-1
Section 8
Technical Specifications .......................................................................8-1
Section 9
Technical Support.................................................................................9-1
To Next Page
Loading...