Atmel AVR ISP - Table of Contents

Table of Contents
i
Table of Contents
Section 1
Introduction...........................................................................................1-1
1.1 Features....................................................................................................1-1
1.2 Device Support .........................................................................................1-2
Section 2
Getting Started......................................................................................2-1
2.1 Unpacking the System ..............................................................................2-1
2.2 System Requirements...............................................................................2-1
Section 3
Hardware Description ...........................................................................3-1
3.1 General Board Description........................................................................3-1
3.1.1 RS-232 Serial Interface ......................................................................3-1
3.1.2 Control Section...................................................................................3-1
3.1.3 ISP Interface Cables...........................................................................3-2
3.2 AVRISP Power Requirements and Considerations ..................................3-2
3.3 Connecting AVRISP to Target Board........................................................3-2
3.4 Handling the ISP Lines .............................................................................3-3
3.4.1 VCC and GND....................................................................................3-3
3.4.2 SCK ....................................................................................................3-3
3.4.3 MOSI/MISO/SCK................................................................................3-3
3.4.4 RESET................................................................................................3-4
Section 4
Software Front-end...............................................................................4-1
4.1 Installing AVR Studio ................................................................................4-1
4.2 Using AVR Studio .....................................................................................4-1
4.2.1 Starting the Windows Software ..........................................................4-1
4.2.2 Starting AVRISP Interface..................................................................4-1
4.2.3 Using AVRISP and STK500 Simultaneously......................................4-2
4.3 AVRISP User Interface .............................................................................4-2
4.3.1 “Program” Settings .............................................................................4-2
4.3.1.1 Device ..........................................................................................4-3
4.3.1.2 Programming Mode......................................................................4-3
4.3.1.3 Flash ............................................................................................4-3