21
PARAMETER SETTINGS
AMP
MODEL: Selects the amplifier model from the list of available amp models. Choose
NONE to bypass the amp model.
ENABLE: Enables or disables the amp modeling effect. Choose ACTIVE to enable the
amp modeling or BYPASSED to disable the amp modeling.
GAIN: Sets the gain control knob of the amplifier from 0.0 (minimum) to 10.0
(maximum).
BASS: Sets the bass control knob of the amplifier tone stack from 0.0 (minimum) to
10.0 (maximum).
MIDS: Sets the mids control knob of the amplifier tone stack from 0.0 (minimum) to
10.0 (maximum).
TREBLE: Sets the treble control knob of the amplifier tone stack from 0.0 (minimum)
to 10.0 (maximum).
PRESENCE: Sets the presence control knob of the power amplifier from 0.0
(minimum) to 10.0 (maximum).
MASTER: Sets the master volume control knob of the power amplifier from 0.0
(minimum) to 10.0 (maximum).
LEVEL (dB): Adjusts the final output level of the amp model. This control helps to
match the level of your preset with other presets.
DAMPING: Adjusts the damping factor of the power amp model from 0% to 100%. Set
at 100% for normal power amp operation. Lowering the damping results in more bass
resonance and more presence.
POWERAMP ENABLE: Separately enable the power amp section of the amp model.
This is a GLOBAL parameter. When using your pedal with a real tube power amp, you
can optionally turn off the simulated tube power amp by selecting DISABLED here.
Most times you will just want to leave this parameter ENABLED.
AMP BUTTON: Assign the AMP ENABLE functionality to the selected footswitch.
Pressing the assigned footswitch will toggle between ACTIVE and BYPASS mode of
the amp model. Please note that the assigned footswitch must be in PRESET ASSIGN
mode.
To Next Page
Loading...
