51
TUNER
AMPLIFIRE features a built-in tuner to assist in tuning up your guitar.
• To ACTIVATE THE TUNER, press and hold the SAVE button for one second or
press and hold any footswitch that is set to enable an effect.
• To EXIT TUNER MODE, press any button.
While in TUNER MODE, AMPLIFIRE will display the closest note and arrows indicating
your tuning in the LCD display window. Adjust the tuning of your guitar until both
arrows point to the center note, indicating the string is in tune.
CLIP WARNING
AMPLIFIRE features a digital clip warning system to alert you whenever your output
signal is driven above the maximum digital levels.
If your signal clips one of the three (3) sets of outputs (MAIN, AUX, or HEADPHONES),
AMPLIFIRE will display a CLIP WARNING in the display windows for 2 seconds. The
CLIP WARNING will also indicate which output pairs clipped. For example, if you see
Main+Aux+HP in the CLIP WARNING message, then you are experiencing digital clips
on all three sets of outputs.
The CLIP WARNING will remain displayed for as long as digital clips continue to occur.
The CLIP WARNING will automatically disappear after two seconds of no digital
clipping.
To help control digital clips, you can do one of the following:
• Reduce the LEVEL knob to lower levels.
• Reduce an effect LEVEL within your preset which may be causing excessive
output.
• Adjust the EQ settings of your preset to lower excessive bass or treble
frequencies.
• Set the individual MAIN OUTPUT, AUX OUTPUT, or HEADPHONE OUTPUT global
settings to help reduce the output level of each set of outputs.
To Next Page
Loading...
