54
EXPRESSION PEDALS CONTINUED...
ASSIGNING EXPRESSION PEDALS
Once the expression pedals are connected, calibrated, and working smoothly, you
can assign them to parameters for continuous control.
When an expression pedal is assigned to a parameter, it does not corrupt the value
of the parameter in the preset (this is to preserve your settings when you choose
to use your presets without expression pedals in the future). The expression pedal
simply overrides the preset value with the value generated by the expression
control.
To ASSIGN A PARAMETER to an expression pedal control, go to the LOOP PARAM
A (or LOOP PARAM B) parameter item in the LOOP menu and select one of the
numerous parameters available for continuous control. To start, you may want to
assign PARAM A to WAH PEDAL and PARAM B to VOLUME PEDAL. These are the
most common parameters used with expression pedals.
After assigning a parameter to an expression pedal, you may want to adjust the
minimum and maximum values of that parameter that the expression pedal will
sweep between.
To Next Page
Loading...
