Section 2. Set Up
_Installation
_Controlling Board
_Machine connection
Installation
This machine should be mounted through the screw holes of truss. Safety
wire is a must to fix fixture well. Make sure truss and safety wire have
strong load capacity to bear 3 times weight than fixture at least.
This machine should be installed by qualified technician.
Master and slave model
Set one of the unit as master, choose auto-running function on the menu.
Set other units as slave, press MENU button to DMX address setting state.
Connect master and slave with signal cable. Then all slave units will run
follow the master.
Atomic4Dj Probeam7R – www.Atomic4Dj.com 6
To Next Page
Loading...
