Need help?Do you have a question about the ATOMRC Dolphin and is the answer not in the manual?
Upper part of the aircraft fuselage.
Lower part of the aircraft fuselage.
The main wing component of the aircraft.
The tail fin component.
The front canopy or hatch.
The rear canopy or hatch.
The nose cone section of the aircraft.
Hatch designed for GoPro camera mounting.
Install standoffs and nuts, securing nylon screws under the board with glue.
Glue the GoPro mount plate, then join the upper and lower fuselage parts.
Install the battery strap and glue the battery mount board to the fuselage.
Install the camera mount plate and attach the V-shaped tail.
Install the side plate on the wing and then attach the control horn.
Glue plastic protection parts onto the wing and the bottom fuselage.
Install magnets on the hatches and glue the sharp nose cone.
Mount the aircraft's motor and electronic speed controller (ESC).
Install servos and push rods, center them, and attach the rudder assembly.
Option to use a carbon plate or foam for camera installation in the nose.
Securely attach the left and right wings to the aircraft fuselage.
Adjust the battery position using the slider for optimal balance after installing GoPro.
Use a rubber band to secure the GoPro, then close the camera hatch.
Install the nose section and the onboard camera.
Adjust the CG 3-4mm forward from the marked point for improved flight control.
Procedure to calibrate the ESC throttle range for proper motor control.
Diagram showing the correct wiring connections for the ESC.
Details on voltage input range, max current, and BEC output.
Diagram illustrating the wiring connections for the VTX Tx15 unit.
Technical specifications including voltage, power, and frequency ranges.
Instructions on how to set band, channel, and power output for the VTX.
To Next Page
General