10
rain the correct siting is; distant from direct
sources ( radiators, direct lighting, etc...)
and protected from direct sunlight and
draughts. Air circulation must be freely
maintained around the condensing unit,
be it integral or remote. In observance of
these specific conditions will detrimentally affect these specific conditions will detrimentally affect
the cabinet.
≥50cm
5.2 INITIAL CLEANING
Before use all parts of the cabinet should be
cleaned,
For the walls and all the internal parts use an
antibacterial detergent.
For the plastic parts use a moistened cloth.
Dry with a soft clean cloth. use little or no
Dry with a soft clean cloth. use little or no
water.
Do not use harsh or abrasive solvents
or detergents
During cleaning do not approach
bare-handed those parts which could
cut ( evaporator, condenser, etc. )and always use protective gloves.
5.3 Electrical connection
Check that the supply conforms to the requirements listed on the factory
label and that it is provided with a fall-safe protection or automatic circuit
To Next Page