GDS ©2016
19
Troubleshooting
TROUBLESHOOTING GUIDE
PROBLEM CAUSE CORRECTION
U.V. lamp will not light Check input voltage if below Install a voltage regulator
or above 120 volts
Electrical cord disconnected Check, replace
or outlet defective
Defective U.V. lamp Replace lamp
Defective lamp ballast Check output voltage
Replace ballast
Loose open-circuit wire Trace out and repair
Leak at quartz nipple Defective or cracked O-Ring Replace O-Ring
O-Ring not seated properly Replace O-Ring
Cracked quartz sleeve Replace quartz sleeve
GDS ©2019 • www.aquat.com
To Next Page
