ATS Systems Ultimate Chuck Installation and Operations Manual
Summary of Safety Instructions
1. Always follow all safety and maintenance instructions in this manual and all other standard
safe shop practices.
2. All operating and maintenance personnel must be properly trained and qualified before
operating, servicing, or repairing the ATS power chucking equipment.
3. Use this power chuck only for its intended purpose.
4. Chuck and workpiece must be protected by an adequate guard at all times when it is rotating.
5. The lathe should be equipped with a chuck actuating cylinder stroke control system and
cylinder pressure control systems as described in this manual section 1.3.2.
6. The operation, lubrication, and maintenance safety warning label shown on the following
page must be attached and prominently displayed on the lathe to which the power chuck
is installed. Carefully heed all points including those relating to:
- maximum RPM limits, use of excessive weight or height top jaws
- proper top jaw mounting bolts
- master base jaw position not extending beyond witness line / "safe" zone
- lubrication
- use of jaw change wrench
7. Take careful note of the sections of this manual marked with the following symbols:
WARNING
ATTENTION
The following maintenance and safety warning label must be attached and
prominently displayed on the lathe to which the Ultimate Chuck is installed.
Danger of injury to personnel if instructions are not followed.
Danger of damage to the machine or the power chuck if
instructions are not followed.
To Next Page
Loading...