What to do if my Aube Technologies TI035 programs do not run as expected?
If the programs on your Aube Technologies Switch aren't running as expected, ensure the switch is correctly programmed. Note that '- : - -' indicates an inactive program. If the switch is configured for a 12-hour format, verify that 'PM' appears on the screen's left side when an afternoon time is displayed.
Why does my Aube Technologies TI035 Switch reset itself?
The Aube Technologies Switch may reset itself because of the load it controls. To solve this, install a snubber (AC130-03) at each relay/contactor.
What to do if my Aube Technologies TI035 display is blank?
If your Aube Technologies Switch has a blank display: * Verify the circuit breaker at the main panel. * Ensure the ON/OFF selector is set to ON. * Reset the switch using a paper clip.
What to do if my Aube Technologies Switch turns back on at midnight?
Any temporary override (bypass) of the Aube Technologies Switch is cancelled at midnight. If you've programmed the switch to turn the light off after midnight and manually turn the light off before midnight, it's an override. This override will be cancelled at midnight, and the light will turn back on. To keep the light off when bypassing programming, set P1 OFF to midnight or earlier.
Why is the Aube Technologies Switch display faded?
A faded or irregular display on your Aube Technologies Switch is caused by an ambient temperature below the freezing point.
Operates as a regular switch, with lights turned On or Off by briefly pressing the switch door.
Follows programmed schedule. Temporary overrides are possible by briefly pressing the switch door.
Enter Latitude, Longitude, Day #, nor/Ad, and Lc values to configure the program.
Use CODE button to select parameters and HOUR/MIN to adjust values for accurate timing.
Press PGM to select time, then CODE to erase. Sunset/sunrise times may revert if programmed.
Check circuit breaker, ON/OFF selector, reset switch, or ambient temperature for display problems.
Ensure MAN/AUTO mode is active and check 12-hour PM display and program settings.
Install snubbers for inductive loads or set P1 OFF to midnight to manage overrides.
General| Brand | Aube Technologies |
|---|---|
| Model | TI035 |
| Category | Switch |
| Language | English |
To Next Page
