AUDAC DPA616 - Chapter 4: Additional Information and Specifications

14
Chapter 4
Additional information
Technical specifications
OutputPower   Stereo@4Ohm 16x60Watt
(1kHz,THD1%)   Stereo@8Ohm 16x30Watt
    Bridge@8Ohm 8x120Watt

Frequencyresponse     20Hz-20kHz
SignaltoNoiseRatio     >100dB
TotalHarmonicDistortion+Noise   <0.1%
Dampingfactor(8Ohm)     110
CommonModeRejection    >65dB
Crosstalk   Pairedchannels >65dB
    Unpairedchannels >110dB
Inputs    Type   8xStereoBalancedLine(16Ch)
    Sensitivity  -20dB~+20dB
    Impedance  20kOhm
    Connectors  3-pinTerminalblock-3.81mm
Outputs   Type   8xStereoLoudspeaker(16Ch)
    Connectors  4-pinTerminalblock-5.08mm
Controls      Gain
       Stereo/Bridge&Parallelswitch
Indicators      Power
       Clip(rear)
Protection      DC-Shortcircuit
       Overheating
       Overload
Coolingsystem      Temperaturecontrolledfan
Amplifiertechnology     Class-D
Powersupply   Type   Switchingmode
    Range   100-240VAC/50-60Hz
Powerconsumption  Idle   47Watt
    1/8Ratedpower 200Watt
    1/3Ratedpower 400Watt
Weight       8.2Kg
Dimensions(WxHxD)     482x88x322mm
Unitheight      2HE