Audi A4 2013 - Page 241

Tire s an d wheel s 239
you have stored. The system does not recog -
nize the load condition of your vehicle.
The effectiveness of the ti re pressu re monitor-
ing syst em* will be impaired if you store nor -
mal load pressures but then operate the vehi -
cle at its maximum load ¢ ,&.
See the illustration ¢
fig. 191 for the location
of the label on dr iver's side B-pillar (color of
the actual labe l and exact location on the ve-
hicle will vary slig htly) .
Note that the fo llowing tab le is accurate at
the t ime of go ing to press and is subject to
I
Model
II
Tire designation
change. In the event of discrepancies, the ti re
pressure label is located on the driver's side B-
pillar always takes precedence .
The t able below lists the recommended cold
ti re inflation pressures for the Audi mode l
covered by your Owner's Literat ure at the vehi-
cle's capacity weight and the t ire sizes instal-
led on the respective models as orig inal
equipment, or as a factory option.
Tire pressure
Engine
normal load condition full load condition
A4 Sedan:
2.0 liter
4-cylinder
allroad:
2.0 liter
4-cylinder
225 / 55 R16 95H
All Season
245 / 45 Rl 7 95H
All Season
245 / 40 R18 93Y
High Performance
225 / 50 Rl 7 94H
All Season
245 / 40 R18 93H
All Season
1255 / 35 R19 96Y XL
High Performance
225 / 55 Rl 7 97H
All Season
245 / 45 Rl8 l00H
All Season
245 / 45 R18 96Y
High Performance
245 / 40 R19 98V XL
High Performance
(up to 3 occupants)
front rear front rear
I
PSI j[ kPA PSI j[ kPA
PSI
Jl kPA
PSI
I[ kPA
32 220 29 200 33 230 35 240
32 220 29 200 33 230 35 240
32 220 29 200 33 230 35 240
•
33 230 30 210 35 24 0 36 250
I
33
230 32 220 36 250 38 260
'
32 220 30 210 35 24 0 35 240
I
30 210 30 210 33 230 36 250
32 220 32 220 33 230 36 250
30 210 30 210 33 230 36 250
32 220 29 200
35
24 0
38
260
-
•
- -
. -
•
•
...