Audi Q5 2009
No. 66, Body, Edition 11.08
3 Partition grid assembly set
7
6
– Insert the respective counterhold bracket into the opening
in the rails and push forward -Arrow-.
– Bring the bracket -4- into the installation position and
screw onto the partition grid -1- with the star grip screws
(small head) -2-.
– Set a distance -A- of approx. 1 cm between the partition
grid -1- and the luggage compartment cover.
– Tighten the star grip screws (large head) -3- slightly.
– Screw the last star grip screws (large head) -3- through
the bracket -4- into the counterhold bracket and tighten
slightly.
– Secure the screws -3- into this position.
– Secure all screws on the upper and lower brackets.
– If available, assemble the space separator ⇒ “4 Space
separator assembly set” on page 8.
– Push the rear seat backrest back and ensure that the
partition grid is not touching the backrest.
The luggage compartment cover and net partition cannot be
used when the partition grid is installed.
WARNING!
Ensure that the securing pins -A- of the counterhold brack-
et are between the securing pins of the support rail -B-.
ZUB-0103
ZUB-0104
A
3
4
1
2
ZUB-0105
3
B AA
4
Note
To Next Page
Loading...
