EasyManua.ls Logo

Audi Q7 2014 - Page 149

Audi Q7 2014
340 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
- You can change the volume and pitch of
the signals as well as the display
Qpage 153.
Cross parking
Applies to vehicles: with Audi parking system plus with
rearview camera
This view may be used when parking in a ga-
rage or in a parking space.
Fig. 169 MMI display: Aiming at a parking space
Fig. 170 MMI display: Aligning the vehicle
"'Sw itch the MMI on and select reverse gear.
"'Th e orange colo red orientation lines @
show the direction of travel of the vehicle.
Turn the steering whee l until the orange ori-
entation lines appear in the parking space
Qfig. 169. Use the markings @ to help you
estimate the distance from an obstacle.
Each marking represents approximately 3 ft
(1 m) . The blue area represents an extension
of the vehicle's outline by approximately
16 ft (5 m) to the rear .
"'Wh ile driving in reverse gear, adjust the
steering wheel angle to fit the parking space
with the aid of the orange orientation lines
c::> A in General Information on page 145,
Q@in General Information on page 146.
@ marks the rear bumper. Stop the vehicle
Parking systems 147
when the red orientation line © borders an
obstacle.
Parallel parking
Applies to vehicles: with Audi parking system plus with
rearview camera
This view may be used when parallel parking
along the side of a street.
Fig. 171 MMI disp lay: Blue surface aligned in the park-
ing space
Fig. 172 MMI display : Contact of the blue curve with
the curb
Parking on the right is described here. It is
identical when parking on the left.
If there is an obstacle next to the parking
space (such as a wall), refer to information for
"Parking next to obstacles"
c::> page 148.
"'Activate the turn signal.
"' Position your vehicle next to a parked vehi-
cle in front of the desired parking space. The
distance to this vehicle should be approxi-
mately 3
ft (1 m).
"' Turn the MMI on and select the reverse gear.
The parking system is turned on and the
cross parking indicator is displayed.
"' Press the control button on the MMI con-
trols @
c::> fig. 171. The parallel parking in-
dicator is displayed.
II>

Table of Contents

Related product manuals