EasyManua.ls Logo

Audi Q7 2014 - Mirrors

Audi Q7 2014
340 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
68 Clear vision
Changing the rear wiper blade
Fig. 69 Rear window wiper Detaching the rear wipe r
blade
Removing the wiper blade
.,. Fold the w indshield wiper arm away from
the glass.
.,. Grasp the upper end of the wiper arm with
one hand and the metal clamp on th e wipe r
blade with the other
¢ fig. 69 .
.,. Hold the wiper arm in the direction of the
arrow @ and pull the w iper blade out of the
holder only in the direction of the arrow @ .
Attaching the wiper blade
.,. Adjust the w iper blade in the holder.
.,. Hold the upper end of the wiper arm with
one hand .
.,. Press the w iper blade into the holder with
your other hand.
.,. Fold the wiper arm back onto the wind-
shield .
A WARNING
For safety reasons, the windshield wiper
blades should be replaced once or twice a
year.
-
Mirrors
Adjusting the exterior mirrors
Fig. 70 Forward sectio n of driver's armrest: powe r mir-
ror controls
Adjusting exterior mirrors
.,. Rotate the knob to the © position (driver's
exte rior m irror) or to the @ position (pas-
senger's exterior m irror)
9 fig. 70 .
.,. Rotate the knob and the mirror so that you
have a clear view to the rear.
Heated mirrors
.,. Rotate the knob to position @ .
Folding both exterior mirrors flat*
.,. Rotate the knob to position @ .
Depending on the outside temperature, the
mirror surfaces are heated until the ignit ion is
switched off - even if the knob is no longer in
position @ .
You are well- advised to fo ld the exter ior mir-
rors in when maneuver ing in tight spaces or
when leaving the car parked close to other
vehicles.
Memory setting for the exterior mirrors*
When th e seat position is saved in the memo-
ry, the position of the exterior mirrors is saved
at the same time
9 poge 74.
If the position of the passenger m ir ror is
changed when the vehicle is in reverse gear
and the switch is in the ® position, this new
ti lted position will be automatically saved to
the remote key when the vehicle is taken out
of reverse gear. To save, the rotary knob for
mirror adjustment must be in the ® position, ...,

Table of Contents

Related product manuals