will remain in effect until you turn off the igni-
tion, assum ing that you have not changed or
reset the setting.
The speed warning symbol . (USA models)/
• (Canada mode ls) in the warning 1 display
appears when you exceed the maximum
speed . It goes out when the speed falls below
t he stored maximum speed.
The speed warning symbo l will also go out if
the speed exceeds the stored maximum speed
by more than about 2S mph (40 km/h) for at
least 10 seconds. The stored maximum speed
is deleted .
Setting speed warning 1 <:!;>page 29 .
Speed warn ing 2
Storing warn ing 2 is recommended if you al-
ways want to be reminded of a certa in speed ,
for example when you a re traveling in a coun-
try that has a general maximum speed limit,
or if you do not want to exceed a specified
speed for winter tires .
The speed warning 2 symbol, . (USA mod-
els)/ . (Canada models) appears in the dis-
play when you exceed the stored speed limit.
Unlike warning 1, it will not go out unti l the
vehicle speed drop s below the stored speed
limit.
Setting speed warning 2
r:!;> page 29 .
@ Tips
Even though your vehicle is equipped with
a speed warning system, you should sti ll
watch the speedometer to make sure you
are not driving faster than the speed lim it.
Dri v er inform a tion di s pl ay 29
Speed warning 1: setting a speed limit
Warning threshold 1 is set by the I CH ECKi
button .
Fig. 23 CHECK button in the instr um ent clust er
Storing the maximum speed
.,. Drive at the desired maximum speed .
.,. Briefly press t he
I CHECK I but t on c::> fig. 23.
Resetting the maximum speed
.,. Drive the veh icle at a speed of at least
3 mph (5 km/h)
.,. Press the
I CHECK ! button for more than 2
seconds.
The speed warn ing symbol . (USA models)/
• (Canada models) will appear briefly in the
display when you release the
!CH E CK I button
to indicate t hat the maximum speed has been
stored suc cessf ully.
The maximum speed rema ins stored until it is
changed by pressing the
!CHECK I button again
briefly or until it is deleted by a lengthy push
on the bu t ton.
Speed warning 2: setting a speed limit
Warning threshold 2 is set, changed and de-
leted in the MMI .
.,. Select:
I CAR I function button > System s*
cont rol button > In strum ent cluster >
Speed warning . Or
.,. Select: ! CAR I func t ion button > Car system s*
cont rol butto n > Driver assist > Speed warn-
ing .
Warning t hreshold 2 can be set in t he speed
range starting from 20 mph to 150 mph ..,.
To Next Page
Loading...
