32 Dr iv er in f ormation d is play
warning goes out after about 5 seconds, but it
can be brought up at any time by pressing the
I CHECK ! button again .
Usually, you can still drive t o t he next dealer -
ship. Turn off all but the most necessary elec-
trica l cons umers, sinc e these drain the vehi-
cle's battery.
(D Note
If the . wa rning symbol (coolant system
malfunction) also lights up on the instru-
ment panel during the t rip ¢
page 32,
then you have to stop immediately and
turn off the eng ine . The coolant pump is
not working anymore - danger of damage
to the eng ine!
BRAKE/(©) Brake system malfunction
A malfunc tion in the brake system mus t be
repaired as soon as possible .
If the warning/ indicator light ~ (USA
models)/ . (Canada mode ls) in t he instru-
ment cluster flashes, there is a brake system
malfunction . By pressing the
I CH ECK ! button,
you can bring up a dr iver message which ex-
pla ins the ma lfu nction in more detail.
Stop vehicle and check brake fluid level
> Pull off the road.
> Stop the vehicle.
>Turnoff the engine .
> Check the brake fluid level ¢
page 267 .
> Cont act you r neares t a ut horized Audi dea ler
or q ualified workshop if necessa ry.
Warning! Fault in brake system. Contact
workshop
> Drive carefu lly to th e nearest a utho rized
Audi de a ler or qua lified workshop and have
the mal function cor rected ¢
&_.
If the ABS system malfunctions, the ABS
war ning/ indica to r light illum inates t oge t her
with the bra ke system mal func t ion warning/
indicator light ¢ &..
A WARNING
- Always observe the war nings in
¢
page 257, before opening the hood
a nd checking the brake flu id.
- Driving with low brake flu id is a safety
hazard . Stop the car and get professiona l
assis tance .
- If the ~ (USA models) . (Canada
models) brake system ind icator light
turns on toget he r with the ABS and ESC
indicator lights, the ABS/ ESC regulat ing
fu nction may have failed. Func t ions th at
st abilize t he vehicle are no longer availa-
ble. This could cause the vehicle to
swerve and increase the risk of s liding.
Drive carefully to the nearest authorized
Aud i dealer or other q ualified workshop
and have the ma lfu nction corrected .
-L Engine cooling system malfunction
A malfunction in the engine cooling system
must be repaired as soon as possible .
When the . symbo l in t he display blinks,
t hen eit her the engine coo la nt
temperature is
too high, or the coo lant
level is too low. An
additional driver message can also be dis-
played by pressing the
I CHECK ! button:
Switch off engine and check coolant level
> Pull off t he road.
> Stop the vehicle.
> Turnoff the engine .
> Check coolant level ¢
page 265.
> Add coo lant if necessary ¢ page 266.
> Continue dr iving on ly after the engine cool-
ant warning/ind icator light goes out.
> Contact your authorized Audi dealer for as -
sistance if necessa ry.
If the engine coolant level is correct, then the
radiator fa n may be the cause of the malfunc-
t ion .
If the . warning symbo l (alternator mal-
funct ion) also lights up on the instrument
panel ¢
page 31, then the fan be lt may be
damaged .
To Next Page
Loading...
